The CWS150S is ideal for panel work, cutting end grain or making tenons. The sliding table runs on a set of bearings giving a smooth and precise action and can be locked in position when not required. The 620mm (24-1/2”) capacity is perfect for cabinet doors. The mitre fence can be adjusted from 90 degrees to 30 degrees each way and is also fitted with a work clamp and flip over stop. A precision ground cast iron table, a steel base cabinet and a 2hp induction motor are the basic ingredients which make up this fantastic spindle moulder. The height of the spindle, which is a standard 30mm diameter, is controlled by the large hand wheel which can then be locked in position. A simple belt change selects the correct spindle speed for the tooling. This 4 speed version provides even more versatility; 1500rpm - Drum Sanding 4500rpm - Moulding Hardwoods 6500rpm - Moulding Softwoods 8500rpm – Routing The cutter hood is cast iron with a dust outlet at the center providing efficient extraction for this machine which can produce a high volume of dust and chips. The two aluminum fence plates are adjustable to set the width of the opening, to suit the cutters being used. The outfeed fence can also be stepped out, controlled by a fine pitch thread adjuster, for operations where the complete edge of the workpiece is being removed. Fully adjustable guards are connected to a hinged plate which can quickly be lifted to allow clear access to change the tooling. Supplied with sliding table attachment, set of spindle shims, 1/2" routing bit collet for, 4 adjustable height rubber feet.
Features: